Extrude Hone Cobra Intake

[BrettT]

https://www.youtube.com/watch?v=2QBc59YZYxA

[Z282SLO]

I thought they were making sausage.

[tricyclerob]

Pretty neat process. Wonder what it cost?

robj

[sc-rcode]

It is fairly expensive,I don't remember exactly what it cost the last time but if you want a little better performance with the stock look it is a good way to go.


Sent from my iPhone using Tapatalk

[BrettT]

It is fairly expensive,I don't remember exactly what it cost the last time but if you want a little better performance with the stock look it is a good way to go.


Sent from my iPhone using Tapatalk

X2, I think it's like $300-400 each for upper and lower


Sent from my iPhone using Tapatalk

[sc-rcode]

That sounds about right I was thinking in the $5-$700 range is what I paid.


Sent from my iPhone using Tapatalk

[9seccobra]

Way back in 1999 I believe I sent my stock manifolds out to them. We measured right about +8rwhp on the AFM dyno. The Cobra was making right around 300rwhp back in those days with the stock short block n/a.

[Z282SLO]

$500-$700 for 8hp? Not a lot of bang for the buck.

[sc-rcode]

$500-$700 for 8hp? Not a lot of bang for the buck.

Yeah Z it's definitely not like buying fireworks!!
I kinda wish I wouldn't of read the +8rwhp part lol!! Sure felt better than that


Sent from my iPhone using Tapatalk

[9seccobra]

Remember mine was naturally aspirated. At the time for me, it was all about trying to keep it look stock. Not so much these days LOL.

[vortech xi]

Do not be fooled this process works and it makes a big difference when you have the proper longblock under the intake manifold.